Flat-Rate Mini Split Installs in Central Texas Homes.

Central Texas summers demand reliable cooling without the hassle of ductwork. ATX Mini Split King offers flat-rate, same-day heat pump installations for homes in Austin and surrounding cities, with no surprise charges after the job starts.

Flat pricing, same everywhere we work

Every install is wired to code by our TDLR-licensed contractor. Long line-set runs, panel upgrades or unusual mounting can add cost, and we tell you up front, before any work starts. For market context, see our Austin mini split cost guide: typical Central Texas quotes run $3,000 to $5,000 for a single zone.

Why Flat Pricing Works for Central Texas Homeowners.

Most HVAC contractors quote ductless mini splits after an in-home visit, often ranging from $2,000 to $5,000 per zone. ATX Mini Split King simplifies the process with fixed pricing: $1,500 for one split, $2,500 for two, and $3,500 for three. These rates cover the unit, labor, and a Home Depot run for touch-up paint if needed, with no additional fees unless an exception like a long line set or panel upgrade is identified upfront.

The flat-rate model eliminates the uncertainty of custom quotes while still accounting for standard installations. Most single-zone setups in Austin-area homes, whether in Round Rock or Georgetown, are completed in a single day. The crew tests the system before leaving, ensuring it cools and heats as expected for Central Texas’s climate extremes.

What’s Included and What’s Not in Your Install.

The flat price covers the mini split unit, refrigerant lines, electrical hookup to an existing circuit, and basic wall mounting. If the installation requires capping old ductwork in a converted room, the crew handles it as part of the job. However, full removal of abandoned duct runs, common in older Austin homes, is typically managed by a general contractor or insulation specialist as part of a larger renovation.

Installations are performed by TDLR-licensed contractors, with most one- to three-zone systems finished in a day. The team flags any non-standard conditions, like a difficult wall mount or a panel upgrade the home already needed, before work begins. This transparency keeps the flat-rate promise intact while ensuring the system meets local code requirements.

Questions

Do you remove old ductwork from walls or attics?

We cap disconnected ductwork as part of the mini split install but do not remove or dispose of it. Full ductwork demolition is usually handled by a general contractor or insulation crew during a broader renovation.

What if my home needs a new electrical panel for the mini split?

If the existing panel lacks capacity, we’ll notify you before starting work. Panel upgrades are not included in the flat rate and require a licensed electrician, which we can recommend but do not perform as part of our service.

Can you install a mini split in a historic home in Austin?

We install the unit and its standard electrical hookup, but historic commission approvals or structural modifications are the homeowner’s responsibility. We’ll work within the approved parameters to ensure compliance.

We install across Central Texas. See the Austin mini split cost guide, full Central Texas service area or Austin mini split installation.